It 'time to install the Blue Point.
The Blue Point Turnout Controller devices are manual controls for turnout that I've used with satisfaction in modules to standard and I'm shivering already fully described in an article published Blog of the same association ( first part, second part , third part, fourth part ).
The Blue Point Turnout Controller devices are manual controls for turnout that I've used with satisfaction in modules to standard and I'm shivering already fully described in an article published Blog of the same association ( first part, second part , third part, fourth part ).
For details about the device and method of its installation refer to the article, here I would only add a small comment about the coupling of the device used with the specific turnout. Atlas
in trade, in contrast to the CEEC, the rod has a lot of "game" in its place, if the control is installed for turnout are not perfectly aligned and aligned with respect to the rod, it is very likely that it works in a non-optimal .
in trade, in contrast to the CEEC, the rod has a lot of "game" in its place, if the control is installed for turnout are not perfectly aligned and aligned with respect to the rod, it is very likely that it works in a non-optimal .
The Blue Point, the problem is easily solved, the four grooves for mounting on the base of the device are, in fact, dimesnioni generous and so permit, to control already installed, small adjustments of position.
After setting the end result is this.
Given the ease of installation in about 1.5 hours I installed all ten devices. Here is a general picture of the finished work ...
... and a detail.
0 comments:
Post a Comment